Forum Replies Created
-
AuthorPosts
-
August 3, 2021 at 10:44 am #37597
martin-ellison
Participantthanks for info now bought one seems o/k just wants tidying up deck has few minor holes nowt to worry about—wheres best place to get main deck bearings that drive cutters
mines is 11/36 dark green –black front as you say can you date em from plate near engine
thanks again martin ps what colour green is itJune 12, 2020 at 5:29 pm #34719martin-ellison
ParticipantJune 12, 2020 at 9:09 am #34704martin-ellison
Participantjust reminising the other night and somebody asked what sort of mower I was using narrowed it down to 1978 when I worked there but as you say could be atcos then painted
June 12, 2020 at 9:04 am #34703martin-ellison
Participantgood call suppose they could be
June 11, 2020 at 11:38 pm #34696martin-ellison
Participantthey were in constant drve all the time even when you took them on road
when mowing 2 across front 3 across back
when on road they all went in single file you only could only go slow like pulling a snake
next time in Harrogate might go see if there still thereMay 18, 2020 at 9:16 am #34415martin-ellison
Participantwhat colour blue was landmaster
May 5, 2020 at 10:26 pm #34214martin-ellison
Participantthank you same has just being said on another forum looks same only difference is the carbaretor
May 5, 2020 at 12:00 pm #34203martin-ellison
Participantfells well balanced –what engine would it be –no plates on it round air cleaner and round exhaust landmaster had briggs and Stratton engines
May 4, 2020 at 11:24 pm #34186martin-ellison
Participanthandles looks as if is orginal if someone has beefed it up its one hell of a job
what sort of engine does it look like— has small round exhaust but end rusted away
thanks for info martinJanuary 14, 2020 at 3:37 pm #33068martin-ellison
Participantthanks that was my question did mine on line thanks martin
August 10, 2019 at 12:54 pm #31716martin-ellison
ParticipantNovember 10, 2015 at 1:20 pm #15161martin-ellison
Participantgood slide show —tie wires and clips to hold info and numbers —as its hard to get pegs in concrete-very good display by club and welcome to be inside out of the rain
November 9, 2015 at 11:41 am #15146martin-ellison
Participantlook on brass plate on side of atco tells cut width and year it was made
October 24, 2015 at 2:21 pm #14988martin-ellison
Participantmy atcos lawnmowwers are in crocker 2 same as last year
October 23, 2015 at 6:26 pm #14923martin-ellison
Participantgot mine today thanks to all—- masham event duncan said everyone forgot to mention martin ellison mowers on display –next to john webster see you all on stand at newark
-
AuthorPosts







