[charlie]

DA1502F is the part number for that half of the case. Looking at the diagram it appears the pulley is a push fit on the shaft, it may be a case of supporting the pulley, applying heat gently and then pressing it off the shaft. You will not be able to remove the key with the pulley on. I will see if I can get to my Barford Atom 15 buried in the shed and if it is an early one see if I can see how the pulley is held on.

[charlie]

Part number BSK 3/16″R is a key for the pulley. Do you know the serial number of your machine? It is probably before A2493.

[charlie]

I have had another look at parts books and have found there is a difference between the gearboxes shown in the combined 15/30 book and the earlier 15 book. It appears you have the earlier 15 gearbox, extract from book below will show what you have. Only leaves question of how does it come apart?

Attachments:

1. 
2. 

[charlie]

I would try a drop of fuel in the plug hole, replace plug and give it a swing see if it fires. Could be a blocked jet in the carb.

[charlie]

It really does pay to spend a few pounds getting the magneto right. A new coil etc for the magneto on my old Hayter produces an excellent spark.

[charlie]

Jeff,looking at database your free trial expired on 27th Nov

[charlie]

It may well be because you are on the FREE trial and not a paid up club member, remember the free trial expires after 30 days. After the 30 days you have the choice of joining the club and having full access to the website and forum or not join and have view only access.

[charlie]

To remove the pulley you need to split the gearbox to gain access to the nut on the inside, part DA1604T, this will enable you to unscrew the pulley (lh thread). To split gearbox remove all nuts and bolts, 8 I think, then gently tap around joint with soft hammer or use hammer and a piece of wood. This should ease the gearbox case apart.

[charlie]

Replacement copy was posted last week. I will send private message to you.

[charlie]

The wire from the switch not being connected will not stop the engine running. However if the end from the engine is touching any of the metalwork it could as it will be earthing the ignition.

[charlie]

This item sold recently on that auction site Hauck catalogue

[charlie]

That number I am guessing is the engine number, no records for those, as it does not match machine serial numbers for that model.

[charlie]

Those decals have survived well, always nice to what they looked like.

[charlie]

Sorted.

[charlie]

Members joining between 1st Sept and 31st Dec have membership to end of following year, this does not include insurance or magazine for current year. Copy of The Cultivator will be available online as soon as i get it uploaded.

[Author]

Posts