[charlie]

The click from the magneto you refer to sounds as if the magneto has an impulse mechanism. This is operated by a spring which is wound up as you turn the magneto and trips to spin magneto faster than you are turning it. This gives a bigger spark for starting, when running the impulse does not operate.
In your list of what you do step a) disconnect HT lead. I dont see any step where you reconnect it!

[charlie]

The photo is not very clear, which does not help. It may well be a machine from Europe, there are several possible names.

[charlie]

I was asked at the weekend how much the 4m x 10m Gala Tent marquee cost, looking on their website they are just under £600. A 4m x 4m one is £340.

[charlie]

A great weekend, looking forward to next years already. A big thank you to Jim, Karen and everyone else involved in organising etc.

[charlie]

Loading up trailer this morning then heading up M4 late afternoon to arrive early evening.

[charlie]

We have a good engineering company just round the corner, P & A Leat, I am sure they could do it. Not sure where you are but they are in Midsomer Norton.

[charlie]

Have you tried John Cruse at The Mower Centre, Hailsham?

[charlie]

August issue will be number 100. Please send all articles, rally reports adverts etc to Alan asap, copy deadline is fast approaching.

[charlie]

A good second hand one may be the only option. More costly option, if the correct gear cannot be found, is to get one made.

[charlie]

I think John means Paul Mackellow.

[charlie]

If what comes out of gearbox looks like good but used old oil I would just refill with new oil, SAE 90. Cutter bar gearbox oil recommended in manual is Shell X100 SAE40. Knife clips should be set to touch knife but allow it to move freely.

[charlie]

Kill switch is not essential but does make stopping the engine easier.

[charlie]

Check wires for continuity, especially from coil to points. Another problem could be high resistance between the back plate, which is aluminium, and items attached to it which use the back plate as a return path.Is HT lead making good contact with the contact point on the coil?

[charlie]

If the engine is a Villiers Mk 12 it should be a 15, the 30 has a Mk15 which is the OHV engine. Looking at the parts list it does not show any bushes.

[charlie]

Welcome to the forum. Looking in the parts book the following belt and pulley options are listed for the cutter bar.
Model 15 9″ OD pulley and an A 40 vee belt.
Councillor tractor 5 3/4″ pulley with B 46 vee belt
Mark 22 tractor 10″ od pulley with A 42 vee belt.
For the tractor an A 43 vee belt
The ratchet hubs may well be full of dust and dirt but are fairly straight forward to take apart.

[Author]

Posts