Forum Replies Created

Viewing 13 posts - 46 through 58 (of 58 total)
1 2 3 4
  • Author
    Posts
  • June 27, 2022 at 2:13 pm #39333
    mitzygolf
    Participant

    Just tried to start it. No fuel mixture getting to the cylinder. Float chamber is filling up and when a little fuel is added straight in to the cylinder it runs. I put a replacement main jet in during the rebuild ,does the taper needle and jet need to be paired? Any ideas would be very helpful. Thanks

    June 25, 2022 at 10:12 am #39270
    mitzygolf
    Participant

    If I put another one on top would it stick?

    June 24, 2022 at 10:16 pm #39267
    mitzygolf
    Participant

    Thanks Charlie. I know you’re an expert, is the transfer the right way up. I didn’t think so the as soon as I applied it

    November 5, 2021 at 9:36 am #38182
    mitzygolf
    Participant

    Hi Charlie, it’s the ones on the Miller drive. Thanks for looking

    November 4, 2021 at 11:09 pm #38179
    mitzygolf
    Participant

    Thanks. I’ve tried 1/4 bsf and 1/4 bsp. bsf was too small, bsp too big. I will try 1/8 bsp. Fingers crossed. Thanks for your reply

    October 5, 2021 at 3:19 pm #38007
    mitzygolf
    Participant

    Hi Charlie, I understand you are the man when it comes to dating Monro tillers. When I bought the tiller it came with the original receipt from 1954. I wonder if you can confirm that date from the ID plate for me. Thanks

    Attachments:
    October 4, 2021 at 3:26 pm #38001
    mitzygolf
    Participant

    Ok thanks

    October 2, 2021 at 1:41 pm #37971
    mitzygolf
    Participant

    Just looked at the chain and it looks very slack. There is no adjustment so should I remove one or two links and fit a connector link?

    September 28, 2021 at 3:44 pm #37951
    mitzygolf
    Participant

    That’s fantastic. Thanks Charlie much appreciated

    September 28, 2021 at 11:42 am #37949
    mitzygolf
    Participant

    Hi Charlie, I don’t know how to message you personally but my email address is (email address deleted to protect privacy) Thanks for your help.

    September 27, 2021 at 2:01 pm #37937
    mitzygolf
    Participant

    Thanks DaveT, found the screw and removed the backplate. Brilliant.I wonder if you can help me with one other question. I took the chain cover off the drive between the engine and tiller section. It was packed with 70 year old grease which I removed. Any idea what type of grease I should re-pack it with. Thanks again for your help

    September 25, 2021 at 12:15 pm #37930
    mitzygolf
    Participant

    Thanks DavaT. I couldn’t load the online page that you posted but have included photos of a parts lost that came with the motivator. Is this what you were referring to?

    Attachments:
    September 24, 2021 at 7:13 pm #37925
    mitzygolf
    Participant

    Do you think this could be it, to the left of the switch wire connection?

    Attachments:
  • Author
    Posts
Viewing 13 posts - 46 through 58 (of 58 total)
1 2 3 4