Villiers 25 governor setting - Vintage Horticultural and Garden Machinery Club

This topic has 1 reply, 2 voices, and was last updated 5 years, 4 months ago by vhgmcbuddy.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
November 19, 2020 at 4:14 pm #35917

donald
Participant

I am restoring, to working order, a Hayter 26 with a Villiers 25 engine and a Zenith 24t carburettor. The engine has a governor with the operating shaft protruding from the engine block and connected to the throttle butterfly via a link. The hand throttle only applies spring tension to one end of the governor rod. Can anybody advise me on setting up the external linkage from scratch?

Many thanks for any assistance, Donald.

November 20, 2020 at 5:25 pm #35938

vhgmcbuddy
Member

I think you can download a Villiers workshop manual to see the set up for the Governer, if not, let me know and I will copy the page from mine. Plonker
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Villiers 25 governor setting - Vintage Horticultural and Garden Machinery Club

Villiers 25 governor setting