Allen scythe" part two.

Home › Forums › The Machinery Forums › Pedestrian operated machines › Allen scythe" part two.

Viewing 10 posts - 46 through 55 (of 55 total)
1 2 3 4
  • Author
    Posts
  • July 19, 2014 at 11:51 am #9356
    vhgmcbuddy
    Member

    A bit more done, just two more coats of the red and this part is ready.

    July 19, 2014 at 2:59 pm #9362
    vhgmcbuddy
    Member

    I was trying to remove the adj screws in the blade pads with some heat but they would not have it! so I had to drill them out and re tap them. Now to make some new screws..

    July 20, 2014 at 7:33 am #9374
    vhgmcbuddy
    Member

    Had an early start today and made the first Adj screw..

    July 21, 2014 at 7:09 pm #9408
    vhgmcbuddy
    Member

    A bit more done this evening, now to order a new cutting bar..

    July 21, 2014 at 7:16 pm #9410
    vhgmcbuddy
    Member

    I have got some new old stock knife bars in the workshop me thinks

    Also some of those screws for the pads??? Have to find them!!

    July 22, 2014 at 7:17 am #9419
    vhgmcbuddy
    Member

    Hi chris,
    I have now made the four Adj screws, but would be very interested in the new cutter bars! do they have all the blades attached ?..

    July 24, 2014 at 8:56 pm #9428
    vhgmcbuddy
    Member

    They sure do!!

    Surface rust but like new. Have to find them when I get a min

    July 30, 2014 at 3:26 pm #9493
    vhgmcbuddy
    Member

    My new set of blades turned up today! and some new springs….

    August 6, 2014 at 7:22 am #9563
    vhgmcbuddy
    Member

    The two blades and drive lug now riveted on..

    August 9, 2014 at 11:40 am #9616
    vhgmcbuddy
    Member

    Fitted the blades this morning and adjusted them up, now for the clutch..

  • Author
    Posts
Viewing 10 posts - 46 through 55 (of 55 total)
1 2 3 4
  • You must be logged in to reply to this topic.