When I bought the Clifford MK1A, It came with a PTO and a Pump(With pressure unit and gauge not shown) I have now stripped these down , freed them up and given them a lick of paint, The PTO would have had a flat belt pulley, swapped for a v belt job, the pump however came without a drive shaft, It seems to have had two parts driven by a simple slot and pin, the one on it was home made, and I have made the extension to mate with the internal drive, What I don’t know is if anything is missing! I see a pair of threaded holes in the “face Plate”, but for what? I could do with an original instruction book or parts list for this pump, so, A Mighty long shot….But if any one has a copy, I would be much obliged. PS I enjoyed meeting up at the GDSF, very helpful blokes, regards to all. Plonker