President plough - Vintage Horticultural and Garden Machinery Club

This topic has 4 replies, 2 voices, and was last updated 7 years, 11 months ago by sjmellors675gmail-com.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
March 23, 2018 at 12:04 am #28237

farmer
Participant

I have a 10″ two furrow plough with some linkage parts missing. I have the top link and RH adjusterble bottom link apparently complete. On the LH side I have the lower link arm and a green bracket and turning handle. I do not know what else I need. The handle turns a threaded bar. What fits on the thread? There is also a hole in this bracket. I believe a bracket goes from this fitting across to the RH frame which does have a bracket fitted. Will someone please send up photographs and dimension to enable me to finally fit the plough to the tractor. Thanks

March 23, 2018 at 12:11 pm #28238
farmer
Participant
Here is a photo of my bracket. I hope that it has attached.
Attachments:
March 24, 2018 at 10:14 am #28242
sjmellors675gmail-com
Participant
Hi hope this pic helps
Attachments:
March 26, 2018 at 11:30 am #28245

sjmellors675gmail-com
Participant

Hi tried to reply over the weekend but was refused so will try now.

I will take some more detailed photos later today, with luck! Will do some measuring as well.

March 26, 2018 at 5:05 pm #28296
sjmellors675gmail-com
Participant
Hi Got the photos.
Top arm 2in hole centres from pivot to screw.
long arm 6in centres.
Attachments:
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.

President plough - Vintage Horticultural and Garden Machinery Club

President plough